Official Luthiers Forum! http://www-.luthiersforum.com/forum/
LMI TRSD Truss rod http://www-.luthiersforum.com/forum/viewtopic.php?f=10102&t=8455	Page 1 of 1

---

Author:	peterm [ Thu Sep 14, 2006 4:27 pm ]
Post subject:
If no adjustment is needed after the neck is setup, I go ahead and turn the bolt just enough to tighten it so it won't rattle but not enough to adjust the neck in either direction.

---

Author:	John How [ Thu Sep 14, 2006 5:01 pm ]
Post subject:
I always put a little dab of "tub & tile" calk in the slot, usually near both ends and the middle. Just a small dab in the bottom of the slot then press the rod down. I've never had a problem with rattles and it dooesn't interfere with adjustments either.

---

Author:	Serge Poirier [ Thu Sep 14, 2006 10:07 pm ]
Post subject:
Good tips guys, Thanks!

---

Author:	John How [ Thu Sep 14, 2006 10:31 pm ]
Post subject:
Hi there Serge, Good morning. It seems you and I are the only ones up at this hour.

---

Author:	Terry Stowell [ Thu Sep 14, 2006 10:40 pm ]
Post subject:

---

Author:	A Peebels [ Thu Sep 14, 2006 11:32 pm ]
Post subject:
I had the same problem with a bass guitar, but just snugging the trussrod took care of it. I use Shoo Goo now. Just a tiny bit does the trick. Al

---

Author:	Serge Poirier [ Fri Sep 15, 2006 12:33 am ]
Post subject:
Hi John, sorry for being late to reply, i guess we woke up a bunch eh?

---

Author:	rich altieri [ Sat Sep 16, 2006 12:27 pm ]
Post subject:
What does "bump" mean?? I see some post this term from time to time

---

Author:	SteveCourtright [ Sat Sep 16, 2006 12:35 pm ]
Post subject:
Rich, "bump" just moves the thread to the top of the stack or list by creating a recent thread entry. It "bumps" the discussion back up to call attention or remind folks that more commentary or discussion is desired.

---

Page 1 of 1	All times are UTC - 5 hours
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/